I previously posted photos of some motorcycle shapes I cut out with my home made 2' x 2' capacity CNC plasma table. I thought I would post a couple of the table itself. It uses mostly off-the-shelf commonly available parts and hardware, and there was little actual fabrication involved.
I keep it outside under my deck, protected by a fire pit cover. The compressor, plasma cutter, and laptop are just inside the basement door. The cables can be connected in 5 minutes for use.
I can provide more details if there is sufficient interest. By the way, I'm retired and am not trying to sell anything - just share information.
I keep it outside under my deck, protected by a fire pit cover. The compressor, plasma cutter, and laptop are just inside the basement door. The cables can be connected in 5 minutes for use.
I can provide more details if there is sufficient interest. By the way, I'm retired and am not trying to sell anything - just share information.
