- Joined
- Aug 25, 2007
- Messages
- 3,890
- Reaction score
- 715
This is an indexing drill press table I built. I picked it up at a local salvage yard, looking pretty much like it does in this picture. I had to turn down the spigot to fit and I also cut the two slots on top for bolting things down. Finally, I modified the hole in the center to take a 5C collet. The holes (and unfortunately, the big square slots) were already drilled. The spacing of the holes is based on 24 although 2 of the 24 have been replaced by the big square cutouts. However, I can work around those pretty easily. The indexing arm on the side was made from hot rolled steel and fastens to the column clamp on the back. I leave this table in the drill press all the time.