Kaleb
Senior Member
- Joined
- Jan 3, 2010
- Messages
- 272
- Reaction score
- 27
Having got my little oscillator to run on steam, I'm setting my sights on something larger and more complex, a double acting engine with a piston valve. The cylinder and valve chest are once again made from copper pipe. The photos were taken a while ago, and I have done a bit more since.
Facing a piece of brass for the rear cylinder cover
Turning the shoulder where the stuffing box will be
Threading the packing nut with an M6x1mm thread
Some parts made so far. Left to Right, cylinder, valve chest, valve, piston.
If you wondered how a piston valve works, here's a slide valve engine:
And this is a piston valve.
Facing a piece of brass for the rear cylinder cover
Turning the shoulder where the stuffing box will be
Threading the packing nut with an M6x1mm thread
Some parts made so far. Left to Right, cylinder, valve chest, valve, piston.
If you wondered how a piston valve works, here's a slide valve engine:
And this is a piston valve.