Demon V8

Help Support HMEM:

michael-au

Well-Known Member
HMEM Supporter
Joined
Dec 18, 2013
Messages
476
Reaction score
407
Front pully partly finished , just need to drill holes. for the fan

Rockercover in this pic is unfinished, was thinking of making one with a breather cap on it, not sure if I use it or not yet

The brass piece is the start of the thermostat

IMG_0700.jpg
 

michael-au

Well-Known Member
HMEM Supporter
Joined
Dec 18, 2013
Messages
476
Reaction score
407
Making the water pump

Two fixtures were made to hold each half while machining

IMG_7374.jpg

Machining the first side

IMG_7291.jpg

Parts are then screwed into the fixture and the second side is machined

IMG_7374.jpg
IMG_7291.jpg
IMG_7410.jpg
IMG_7374.jpg
IMG_7291.jpg
IMG_7410.jpg
IMG_7395.jpg
IMG_7401.jpg
IMG_7402.jpg
 

michael-au

Well-Known Member
HMEM Supporter
Joined
Dec 18, 2013
Messages
476
Reaction score
407
Hullo again all parts for files cheers

Hi
If you are building this engine you should consider making a build log on this site

If you need help there are good people on here that can help you out

the plans are copyright
 

michael-au

Well-Known Member
HMEM Supporter
Joined
Dec 18, 2013
Messages
476
Reaction score
407
Some progress on the distributor, I have not machined the mounting point as yet, I will wait until the inlet manifold is made I'm thinking I might tighten it down with a clamp, not sure yet

IMG_0799.jpg
IMG_0800.jpg
IMG_0801.jpg
IMG_0802.jpg
IMG_0803.jpg
 
Last edited:

michael-au

Well-Known Member
HMEM Supporter
Joined
Dec 18, 2013
Messages
476
Reaction score
407
Made a start on the heads

I think these are going to take a while there is a lot of work in them

IMG_0805.jpg
IMG_0806.jpg
 

michael-au

Well-Known Member
HMEM Supporter
Joined
Dec 18, 2013
Messages
476
Reaction score
407
Base of the carby machined out ready to be finished off in the 4th axis


IMG_0804.jpg
 

rrocky

Active Member
Joined
Apr 1, 2016
Messages
29
Reaction score
1
Location
Australia
Hi
If you are building this engine you should consider making a build log on this site

If you need help there are good people on here that can help you out

the plans are copyright
yes i am building this engine and i have a set of plans, I am talking about sharing the G code to make the parts that you have made cheers
100_1897.JPG
100_1897.JPG
 

Attachments

Top