Hello folks
Well I'm starting a new project, and hope it will end better than the previous two projects, which I must admit, has been placed on the "might work one day" shelf.
The new project is a 45mm Loco - the 020 DeCauville, just like this :
http://www.homemodelenginemachinist.com/f31/decauville-finished-20988/
Must say this looks as a very nice job done.
My progress so far :
I would like to know if anyone could tell me if the wheels is to be pressfitted to the shafts, or if they are attached another way.
TIA
Well I'm starting a new project, and hope it will end better than the previous two projects, which I must admit, has been placed on the "might work one day" shelf.
The new project is a 45mm Loco - the 020 DeCauville, just like this :
http://www.homemodelenginemachinist.com/f31/decauville-finished-20988/
Must say this looks as a very nice job done.
My progress so far :
I would like to know if anyone could tell me if the wheels is to be pressfitted to the shafts, or if they are attached another way.
TIA