Hi,
I've noticed when I use my mill there are a couple of tight spots on the table feeds.
From what I've read here I'm guessing there are a few burs and in there that need cleaning off but I've never dismantled anything like this before.
Does anyone have any hints / tips or photos on how I should disassemble the table and any traps I need to be careful of?
Thanks
I've noticed when I use my mill there are a couple of tight spots on the table feeds.
From what I've read here I'm guessing there are a few burs and in there that need cleaning off but I've never dismantled anything like this before.
Does anyone have any hints / tips or photos on how I should disassemble the table and any traps I need to be careful of?
Thanks