I wanted to offer this here first before I put it on e-bay.
I have the plans and DVDs of Rudy Kouhoupt last engine (the Pioneer) as advertised in The Home Shop Machinist.
It is a Non-Compression Internal Combustion 2-cycle Engine. Made from bar stock and without any gears.
There are 12 sheets of full-sized drawings and 2 DVDs (3 hours, 50 min).
I have built this engine and it was a good and fun build. (I learned a lot from building it) all you need is a small lathe 7X, and a mini-mill and yes the engine dose run, I did how ever have go to a larger Spark plug (CM-6X10 MM).
The DVDs and Plans cost me $79.95 + postage if any one would like to have them I can let them go for $40.00 US and that will include postage any where in the US.
You can e-mail me @
[email protected]
Thank you for your time,
Richard
Has been sold.
Thanks
I have the plans and DVDs of Rudy Kouhoupt last engine (the Pioneer) as advertised in The Home Shop Machinist.
It is a Non-Compression Internal Combustion 2-cycle Engine. Made from bar stock and without any gears.
There are 12 sheets of full-sized drawings and 2 DVDs (3 hours, 50 min).
I have built this engine and it was a good and fun build. (I learned a lot from building it) all you need is a small lathe 7X, and a mini-mill and yes the engine dose run, I did how ever have go to a larger Spark plug (CM-6X10 MM).
The DVDs and Plans cost me $79.95 + postage if any one would like to have them I can let them go for $40.00 US and that will include postage any where in the US.
You can e-mail me @
[email protected]
Thank you for your time,
Richard
Has been sold.
Thanks