Sshire
Well-Known Member
- Joined
- Jun 29, 2011
- Messages
- 936
- Reaction score
- 259
My lathe is semi-of-out-of-commission until the new power supply for the carriage feed motor arrives on Tuesday.
This seemed like a good time to put the "new" Oliver S-4 Die Filer in a proper environment.
The stand (until this morning) held a Delta Thickness Planer for wood. It will probably go to the next Cabin Fever auction.
The switch was from Amazon. The Oliver never had a switch. I guess the first shift plugged them in and 8 hours later unplugged them.
PVC pipe from a friend's swimming pool extras when they installed the heater.
The magnifying lamp has been around the shop forever.
I'm going to put a small partition between the Oliver and the red blast cabinet behind it. I have the cabinet well sealed and really get no glass beads trying to escape, but I'm just protecting Oliver.
This seemed like a good time to put the "new" Oliver S-4 Die Filer in a proper environment.
The stand (until this morning) held a Delta Thickness Planer for wood. It will probably go to the next Cabin Fever auction.
The switch was from Amazon. The Oliver never had a switch. I guess the first shift plugged them in and 8 hours later unplugged them.
PVC pipe from a friend's swimming pool extras when they installed the heater.
The magnifying lamp has been around the shop forever.
I'm going to put a small partition between the Oliver and the red blast cabinet behind it. I have the cabinet well sealed and really get no glass beads trying to escape, but I'm just protecting Oliver.
