student123
Well-Known Member
- Joined
- Oct 31, 2009
- Messages
- 183
- Reaction score
- 0
I'm building the little machine shop oscillator - I've drilled/reamed the cylinder (in ali - the piston is brass). Later I will also need to lap the outside of the ali cylinder to an upright (also in ali).
Looking in the cupboard my choices seem to be t-cut or toothpaste...
(presumably cutting fluid not suitable?)
Can I use t-cut to lap the inside of an ali cylinder bore ?
Mike
Looking in the cupboard my choices seem to be t-cut or toothpaste...
(presumably cutting fluid not suitable?)
Can I use t-cut to lap the inside of an ali cylinder bore ?
Mike