MIG welding low cost FYI

[SmithDoor]

I have upload a copy of the Manual to the downs if any want to view the doc
http://www.homemodelenginemachinist.com/downloads/welder-fds-wolf-mig-130-322.html

Page 11 and 12 have additional information on duty cycle and voltage:thumbup:

Dave

 

[Nick Hulme]

Note: Gunsmith work is low pay I can go back to work as a journeyman machines working some one else and make far more that a self employed Gunsmith

Dave

So why are you using a logo for a trade which you are openly denigrating?

 

[SmithDoor]

I am NOT denigrating gunsmith work
I was Lic in CA as gunsmith for years and at that time I joined this group.
I only let others know it is not same pay as journeyman repair machines

I am very proud of being a Gunsmith:thumbup:
Dave

So why are you using a logo for a trade which you are openly denigrating?

 

[10K Pete]

I'm here to tell ya that 95% of gunsmithing hardly makes wages.

Pete

 

[Nick Hulme]

I'm here to tell ya that 95% of gunsmithing hardly makes wages.

Pete

Pete,
You are kind of right, most people think gunsmithing is the same as mechanic work, and most think that fitters are mechanics.

If you can't run a mill, lathe, grinder, heat treat furnace etc. and make a revolver and/or a semi-auto from stock you're kidding yourself and you're a fitter, not a gunsmith, plain and simple!

- Nick

 

[10K Pete]

Pete,
You are kind of right, most people think gunsmithing is the same as mechanic work, and most think that fitters are mechanics.

If you can't run a mill, lathe, grinder, heat treat furnace etc. and make a revolver and/or a semi-auto from stock you're kidding yourself and you're a fitter, not a gunsmith, plain and simple!

- Nick

Abso-f-ing-lutly correct!!!!!

Pete