gunboatbay
Well-Known Member
- Joined
- Jan 31, 2008
- Messages
- 87
- Reaction score
- 1
In one of the other forums, a member had a problem with stress distortion when he was attempting to mill some strips of brass to thickness for gib strips. In the ensuing discussions, one member contributed this URL:
http://www.brass.org/Publicat/pub117/117-section-5-how-to-make-it-in-brass.pdf
I'm sure all this is well known to experienced machinists, but for the less experienced, there's a lot of good information, so I thought I'd pass it on. The temperature requirements for annealing don't seem very critical and well within the range of a countertop toaster oven.
http://www.brass.org/Publicat/pub117/117-section-5-how-to-make-it-in-brass.pdf
I'm sure all this is well known to experienced machinists, but for the less experienced, there's a lot of good information, so I thought I'd pass it on. The temperature requirements for annealing don't seem very critical and well within the range of a countertop toaster oven.