Does anyone know how to make TurboCNC deal with either conditional logic or counters? The GCode is very simple, and there are no instructions that I've seen documented for the interpreter that does this.
I don't think I'll be using TurboCNC forever, but it was just the easiest thing to get up and running quickly on the low-end PC that I had sitting around here. Suggestions for my next installation would also be appreciated.
-Sparky
I don't think I'll be using TurboCNC forever, but it was just the easiest thing to get up and running quickly on the low-end PC that I had sitting around here. Suggestions for my next installation would also be appreciated.
-Sparky