Wondering if anyone has removed the drawbar from this machine? It is apparently captive in the spindle. I would like to replace it. I spoke with a BB rep and he seemed to think it could be removed once the tooling it holds is released. No go.
Does it come out upwards or downwards (dropping out thru the MT3 spindle)?
I don't see anything directly holding it in place; however, it neither drops down nor can it be removed upwards - at least, not without some trick(s). It must be more than just a long bolt; otherwise, why can I not remove it?
Does it come out upwards or downwards (dropping out thru the MT3 spindle)?
I don't see anything directly holding it in place; however, it neither drops down nor can it be removed upwards - at least, not without some trick(s). It must be more than just a long bolt; otherwise, why can I not remove it?