Bandsaw Vise

[Stan]

While I am in photobucket, I will post a picture of my answer to cutting small pieces on the 4x6 bandsaw. It is just a $3.00 2" drill press vise which mounts to a piece of angle that is permanently affixed to the side of the saw table.

http://i272.photobucket.com/albums/jj165/sdmcw/TaperAttachment7.jpg[/img]]

 

[black85vette]

like your idea a lot. In my post about a vise on the bandsaw I put it in the clamp of the saw. We both cut off one side of a cheap drill press vise. The mount to the outside on this one leaves plenty of room to the inside. Now I will have to install some angle iron so I can do it both ways.

Good job! Thm:

 

[Kermit]

And a super Big - "Me Too"

from me too!


Wonderful kink. Thank you sir, for the mod idea.
Kermit