14MM ID BOSS WITH A 12MM STUD FOR ADAPTATION TO UNIMAT 3 MILL TO HOLD COLLETCHUC

[360DEGREE GEARHEAD]

I NEED A COUPLING MADE OUT OF SOME 303 STAINLESS THAT HAS ONLY .0005 RUNOUT. SINCE I CAN'T FIND A REGULAR UNIMAT3 COLLET CHUCK THEN I'L ADAPT MY UNIMATDB200 COLLET CHUCK TO USE WITH THIS COUPLING TO FINALLY USE MY MIIL THE COLLETCHUCK HOLDS THE END MILLS.

ALSO TRYING TO FIND A HEAVY 10" SOUTH BEND 54" LEAD SCREW IN GOOD CONDITON FOR A HEAVY SB. 10" RESTORATION.

I'M, ALWAY SEEKING GOOD TOOLING FOR MY 10" TO 15" ALORIS TOOL POST
BXA I THINK IS THE DESTINATION FOR THE 10" TO 15" LATHE SIZE. COULD BE OFF A LETTER

A SB SMALL 9" BED TURRET; A SB 10" BED TURRET; ANY UNIMAT 3 TOOLING OR
ACCESSORIES.

 

[Noitoen]

Please don't shout Everybody can hear well over here ;D