Wiring teco VFD to my enco 13x40 lathe

Discussion in 'Introduction' started by EJay, Jul 19, 2019.

Help Support HMEM by donating:

  1. Jul 19, 2019 #1

    EJay

    EJay

    EJay

    Member

    Joined:
    Jul 19, 2019
    Messages:
    5
    Likes Received:
    0
    Gender:
    Male
    Location:
    Michigan
    Hello to everyone,

    I new to this site. I recently bought a teco VFD (p/n L510-203-h1-u) for my Enco 13x40 engine lathe. Does anyone have a schematic? I'm a machinist by trade. Not an electrician. So any help would be appreciated. I pulled off the front switch panel. There is a red(activates the motor switch),dark blue(activates green start button),light blue(activates coolant pump), and pink((hot wire which is ran thru all switches) which are ran to a buss bar on the back side of lathe. Can I hook up off the buss bar? Or should be hooking up on the other side of the contractors? I still having a hard time to decifering the wiring for the forward/reverse lever and the foot brake. Thanks for the help.
     
  2. Jul 19, 2019 #2

    TonyM

    TonyM

    TonyM

    Well-Known Member Project of the Month Winner

    Joined:
    May 15, 2017
    Messages:
    227
    Likes Received:
    119
    Gender:
    Male
    Occupation:
    Retired
    Location:
    North Bohemia Czech Republic

Share This Page