I like putting 45° chamfers on everything I make on the surface edges of the part but it's always hard to hit the same amount of chamfer on all edges. Recently I've been clamping the work on a little pair of V blocks that I made and touching off the top of the corner with a endmill and facing the corner down a specific Z. This hit's all the corners equally but it is very time consuming and fairly precarious. The other thing I've done is usa a 45° chamfer endmill but that is where I find it hard to make sure my chamfer depth is the same on all edges.
Any hints? I got inspired by the corner rounding thread and I may try a touchoff system like that.
Any hints? I got inspired by the corner rounding thread and I may try a touchoff system like that.