JMI
Well-Known Member
I have an William's FP-AG-TK rear aperture (peep) sight https://www.airgunsofarizona.com/WilliamsGunSights.html on a air rifle that I need to be able to lower a little more then currently possible. It is a very simple job but can easily be screwed up. Just want to remove .050 thousandths from base of aperture carrier with surface area of less then 1/2 square inch total.
I was a frequent poster here awhile back but no longer have access to any machine tools (that may change).
I can pay $25 for the job. If you are a careful machinist and are interested, email me and i can send more info/pictures of exactly what needs to be done.
Thanks
Jim
[email protected]
I was a frequent poster here awhile back but no longer have access to any machine tools (that may change).
I can pay $25 for the job. If you are a careful machinist and are interested, email me and i can send more info/pictures of exactly what needs to be done.
Thanks
Jim
[email protected]