ScrapMaker
Member
- Joined
- Mar 22, 2009
- Messages
- 5
- Reaction score
- 0
Hi all,
Somethings starting to bug me about my tail stock. When I setup my lathe, i made sure that everything was lined up correctly.
on a 12" bar i had less than a thou run out from one end to the other. But when I came to centre drill and then drill the end of the stock, problems arise.
For some reason the chuck always lifts up and to the right when doing any operations using the tail stock eith drill chuck mounted.
There is no movement in the tail stock, even when it is fully extended.
Any ideas what could be causing this?
Thanks
Somethings starting to bug me about my tail stock. When I setup my lathe, i made sure that everything was lined up correctly.
on a 12" bar i had less than a thou run out from one end to the other. But when I came to centre drill and then drill the end of the stock, problems arise.
For some reason the chuck always lifts up and to the right when doing any operations using the tail stock eith drill chuck mounted.
There is no movement in the tail stock, even when it is fully extended.
Any ideas what could be causing this?
Thanks