- Joined
- May 27, 2010
- Messages
- 2,999
- Reaction score
- 1,171
Saw foto of Taig Boring Head which is good size match for my Sakai Mini Vertical Mill which is not much bigger than Taig's. Sakai BH is about same size but will cost Gus a ''Bomb'' courier in.The existing BH is a bit
chunky and clunky.
I happen to have the 1 1/2" Bright Mild Steel Bar stock on hand.Hopefully when Nemett-Lynx Engine is done and running in a month of two,will DIY this Taig BH.
See foto taken of Dean's. Formum members who have built same or have not or have yet,do feel free to give expert advice to Gus.
Your expert advice is welcome.
chunky and clunky.
I happen to have the 1 1/2" Bright Mild Steel Bar stock on hand.Hopefully when Nemett-Lynx Engine is done and running in a month of two,will DIY this Taig BH.
See foto taken of Dean's. Formum members who have built same or have not or have yet,do feel free to give expert advice to Gus.
Your expert advice is welcome.
Last edited: