metaldestroyer
Member
- Joined
- Nov 11, 2010
- Messages
- 13
- Reaction score
- 0
I have been considering purchasing a set of Little Hogger 1" end mills. As the subject line indicates improved surface finish is at least one of my main objectives. Normally I machine a lot of 4140 and in the lathe I get what I consider a nice finish, but in the mill at present I use HS end mills and surface finish is not that good. I have an old mill that has too much slack to clime mill safely so I am wondering if the negative rake will help improve it. Anyone here have any experience with this?
Regards Jack
Regards Jack