Sherline mill not co-operating...

[lazylathe]

Hi All!

I was fly cutting some Alu down to 1/4" thickness and have found a problem with my mill.
One side was much thicker than the other.

So i stripped the mill again to verify everything and found this:
When i have the vertical column squared on one side, the other side of the column is off.
This leads me to believe that the X Table is not square to the column.

When the square is showing no light against the left side of the column i get a gap of +- 0.020 at the bottom of the column on the right side. ???

Is there a way to square up the table to the column on this mill?
I know there should be, i just don't have a clue... scratch.gif

Any help would be greatly appreciated!! :bow:
The project is at a standstill.... :'(

 

[steamboatmodel]

Sherline website Aligning a Sherline Mill
http://www.sherline.com/millalin.htm
Regards,
Gerald.