HI all
I had mobility scooter back end that had the frame and gears and whatnot, and
since i don't have a workbench i usually hold the pieces in my drillpress vice when I'm hacksawing.
Anyway I started to test out the scooter parts and the happend to be mostly the right size i needed, with just a little modding.
Its not done yet but i think it should work ??? ??? ??? Its kinda funny i think
and makes me giggle a little ;D.
Here it is so far.. I still need to drill a couple of holes and finish the transmission.
The gear on the chuck came from the transmission of the scooter and are 45 deg bevel gears allowing to move the movement out to 90 deg as you can see..
I still need to find a belt to replace the rubber bands, those are just for show.
I also did'nt drill the holes for the blade and put one on if that confuses you. The hacksaw frame
is the other half of the scooter frame, forming the upright support.
It slides on the bar back and forth and can move up and down on the pivot.
More to come... I hope to finish it sometime in the next week if i can find a belt.
Chris
I had mobility scooter back end that had the frame and gears and whatnot, and
since i don't have a workbench i usually hold the pieces in my drillpress vice when I'm hacksawing.
Anyway I started to test out the scooter parts and the happend to be mostly the right size i needed, with just a little modding.
Its not done yet but i think it should work ??? ??? ??? Its kinda funny i think
and makes me giggle a little ;D.
Here it is so far.. I still need to drill a couple of holes and finish the transmission.
The gear on the chuck came from the transmission of the scooter and are 45 deg bevel gears allowing to move the movement out to 90 deg as you can see..
I still need to find a belt to replace the rubber bands, those are just for show.
I also did'nt drill the holes for the blade and put one on if that confuses you. The hacksaw frame
is the other half of the scooter frame, forming the upright support.
It slides on the bar back and forth and can move up and down on the pivot.
More to come... I hope to finish it sometime in the next week if i can find a belt.
Chris