My toys

[lorierda]

Hi,

Here are my little toys. My lathe 7X12, a Barker benchtop mill, a Misal milling modified for production and my favorite an Induma MM200 milling.

The Misal and Induma are 3 phases but I don't have it for moment. I can't change the motor of the Misal because I need the two speed from the 3 phases motor. I changed the 10 hp motor on the Induma for the moment, now I can work with... very interesting machine.

My lathe do almost every job I need and if it is too big I make a special setup on the Induma.

 

[rake60]

Welcome to HMEM lorierda

Nice toys!

Rick

 

[tattoomike68]

Very nice tools, Welcome .

Its just too bad we cant have 3 phase at home.

 

[Brass_Machine]

Nice toys!

Welcome to the site by the way!

Eric

 

[lorierda]

Yes it's a problem without 3 phases but I think I find a cheaper solution than a phase converter. If all the controls are on single phase I have to buy a bigger motor than the 2,5hp I put on it (Induma). After that just to verify the drive and some connector to find the little problem about the X - Y - Z cluthes don't work more than 2 secondes.