ksor
Well-Known Member
- Joined
- Jul 18, 2007
- Messages
- 188
- Reaction score
- 14
I have some problems with these motors 
I have 3 motors operating on the same peace of alu.
The motors do the following - Lift it up 35 mm, turn horisontaly 90 degrees, lower it 20mm.
When I make an animation all 3 motors individualy functions well and in combinations of 2 motors works well too, but all 3 can't run - one of them is red and no frames are shown for the red motor !
What do I do wrong ?
I have 3 motors operating on the same peace of alu.
The motors do the following - Lift it up 35 mm, turn horisontaly 90 degrees, lower it 20mm.
When I make an animation all 3 motors individualy functions well and in combinations of 2 motors works well too, but all 3 can't run - one of them is red and no frames are shown for the red motor !
What do I do wrong ?
