SignalFailure
Well-Known Member
- Joined
- Jan 1, 2008
- Messages
- 366
- Reaction score
- 3
I made this bronze part (about 1/2" deep x 1.25" long) on my new micro mill yesterday using a 10mm end mill. Overall the finish is good but the vertical face at the right-hand end has a tiny 'step' (where that last white vertical line/flash reflection is).
When I turned the piece around and did the other side exactly the same thing happened. Fortunately I can rescue the part with some judicious filing ;D
Can anyone suggest what the cause of this 'step' is?
Thanks in advance!
When I turned the piece around and did the other side exactly the same thing happened. Fortunately I can rescue the part with some judicious filing ;D
Can anyone suggest what the cause of this 'step' is?
Thanks in advance!