I've seen many references to machinist's jacks being a good project to start with on the lathe. I agree, these are simple things that allow you to practice a few skills... BUT:
I have yet to see them in use!
I've considered the idea of using three of them under a piece to be milled, allowing the top side to be tilted very precisely, or leveled completely, but the stability of such a setup is concerning to me.
I'd love to see a few photos of how and where to use them. Maybe then I'll be convinced to whip up a few.
Thanks..
-Brian
I have yet to see them in use!
I've considered the idea of using three of them under a piece to be milled, allowing the top side to be tilted very precisely, or leveled completely, but the stability of such a setup is concerning to me.
I'd love to see a few photos of how and where to use them. Maybe then I'll be convinced to whip up a few.
Thanks..
-Brian