Hi all,
Would anyone know whether this rotary table would be ok (rigid enough, etc.) for cutting gears (up to about 6in) ? : http://www.machineryhouse.com.au/R001
Also, is the degree of turns (IYSWIM - 10 minutes in this case) small enough for most teeth numbers? (i.e. 52 teeth)
Thanks from a newbie. I hope the question isn't too stupid or generic...
Would anyone know whether this rotary table would be ok (rigid enough, etc.) for cutting gears (up to about 6in) ? : http://www.machineryhouse.com.au/R001
Also, is the degree of turns (IYSWIM - 10 minutes in this case) small enough for most teeth numbers? (i.e. 52 teeth)
Thanks from a newbie. I hope the question isn't too stupid or generic...