Seeing that my twin project is coming along well so far I would like to approach the forum for advise or help in the next design. I have been working on a design for a twin cylinder IC engine that is gearless in nature and it uses a cantilever connecting rod. The crankshaft will run in either direction with a simple timing adjustment.
What I am suggesting is that if there is anyone out there that would like to draw the engine in solidworks and then build it I will make the idea available to them and I will help with support. I can supply some sketches to describe what I have in mind. As I don't like to draw and can only draw in 2D I was just wondering if any of you expert draftsmen would like a challenge. PM me if you think you would like a project such as this. My goal would be to have working drawings available to anyone wanting to build it here at the forum. Let the input fly, Dave
What I am suggesting is that if there is anyone out there that would like to draw the engine in solidworks and then build it I will make the idea available to them and I will help with support. I can supply some sketches to describe what I have in mind. As I don't like to draw and can only draw in 2D I was just wondering if any of you expert draftsmen would like a challenge. PM me if you think you would like a project such as this. My goal would be to have working drawings available to anyone wanting to build it here at the forum. Let the input fly, Dave
