- Joined
- Jun 4, 2008
- Messages
- 3,285
- Reaction score
- 630
I had seen this torch set at an engine show last year, and also at NAMES this year. I bought it as an "impulse purchase" at NAMES, but didn;t get it out until today. I needed to silver solder two pieces of steel that were too large for the MAPP torch. Success!
The principle of these torches is low flow oxy-acetylene (4PSI for both gases) giving high heat very close to the torch tip in a very small area. In fact, you can weld thin sheet metal without it distorting. The small tanks supposedly last a long time.
The torch handle has an attachment for cutting as well.
The principle of these torches is low flow oxy-acetylene (4PSI for both gases) giving high heat very close to the torch tip in a very small area. In fact, you can weld thin sheet metal without it distorting. The small tanks supposedly last a long time.
The torch handle has an attachment for cutting as well.