Tomo1
Active Member
- Joined
- Apr 17, 2013
- Messages
- 32
- Reaction score
- 4
Hi Everyone....
Just new to this site and machining in general. (Apart from metalwork in highschool/)
I have been for a while been planning a small v8. Decided to take a small step first and test the design as a single cylinder then go from there. Only problem is that that my workshop is in storage while we are at the in-laws for a few months. The only area I have is a 2.5x2.5m room which is also my office for work.
So to keep mess and noise to a minmun I have recently aquired a chinese version of a Unimat Classic 1. I understand that I am most likely in for a world of hurt with that one :wall:. But for some strange reason am looking forward to the challenge. At least I can get started on the engine...
Would be interested to see if anyone else has had experience with a Unimat1?
As soon as i get some photo's of the initial engine parts I will get them posted.....
Just new to this site and machining in general. (Apart from metalwork in highschool/)
I have been for a while been planning a small v8. Decided to take a small step first and test the design as a single cylinder then go from there. Only problem is that that my workshop is in storage while we are at the in-laws for a few months. The only area I have is a 2.5x2.5m room which is also my office for work.
So to keep mess and noise to a minmun I have recently aquired a chinese version of a Unimat Classic 1. I understand that I am most likely in for a world of hurt with that one :wall:. But for some strange reason am looking forward to the challenge. At least I can get started on the engine...
Would be interested to see if anyone else has had experience with a Unimat1?
As soon as i get some photo's of the initial engine parts I will get them posted.....