chucketn
Senior Citizen
I purchased a 1 axis stepper driver board on e-bay. I expected it to come with an application data sheet or info on how to hook it up, but it didn't.
Picture here: http://s571.photobucket.com/albums/ss157/chucketn/Digital RT controller/
On the left is the input from the control circuit from top to bottom +5v, Pul, Dir and EN. I do not know what values PUL, DIR and EN should be.
On the right from top to bottom: A+, A-, B+, B-, +24V, GND.
This driver is to become part of my Digital RT controller project.
Anyone familiar with this Stepper Driver? It's based on the TB6560AHO chip.
Can anyone suggest a simple test setup to see if it works?
I have a TEC CBA45-01101 3v unipolar stepper I want to drive with it.
I also have 5VDC and 12VDC wall warts to provide power for testing. I do know from the E-Bay listing it can handle 12-24v for stepper supply.How can I provide simple Pul, Dir and EN signals to the input? Can I safely drive a 3v stepper with 12v?
Mods if this post should be in another sub board, please let me know.
Chuck
Picture here: http://s571.photobucket.com/albums/ss157/chucketn/Digital RT controller/
On the left is the input from the control circuit from top to bottom +5v, Pul, Dir and EN. I do not know what values PUL, DIR and EN should be.
On the right from top to bottom: A+, A-, B+, B-, +24V, GND.
This driver is to become part of my Digital RT controller project.
Anyone familiar with this Stepper Driver? It's based on the TB6560AHO chip.
Can anyone suggest a simple test setup to see if it works?
I have a TEC CBA45-01101 3v unipolar stepper I want to drive with it.
I also have 5VDC and 12VDC wall warts to provide power for testing. I do know from the E-Bay listing it can handle 12-24v for stepper supply.How can I provide simple Pul, Dir and EN signals to the input? Can I safely drive a 3v stepper with 12v?
Mods if this post should be in another sub board, please let me know.
Chuck