Replacement jaws on Skinner 3 jaw chuck.

[CMS]

In an earlier post about a 6" three jaw chuck, I've done all I can think about doing to get the lope out but replacing the the jaws. So how or what do I measure for new jaws. Or has someone here already went through this and have a part number? The chuck is a Skinner #K3906.

 

[Stan]

Since nobody replied to this in a week, I will give my opinion. Replacement jaws, especially for old chucks are just about an impossibility. I have read that some of the large used tool dealers have piles of unidentified jaws that you can pick through but other than that, not much hope.

 

[deverett]

Stan

If you are prepared to go 'across the water' you might try

http://rotagriponline.com/index.php?
option=com_virtuemart&page=shop.browse&category_id=33&Itemid=29

Dave
The Emerald Isle