I need some advice on how to prevent my tool holders and drill chucks with a MT#3 taper with tang from falling out of the quill on my mill during use.
Also, I have a set of collets which are held in the quill with the draw bar. The collets will not hold my endmills or drill bits securely. What I mean is that the end mill will creep up into the collet.
I have one MT#3 x 3/8" mill holder that has a female thread for the draw bar. This one works OK. The endmill is held in place with a set screw. If I could afford it I would buy these holders for each size of tool.
So, after saying all of that, I need help with these two issues.
1-How do I keep tooling with the MT-3 and tang from falling out of the quill?
2-How can I hold various sizes of tooling with my Collete's securely?
Thanks for your help.
SAM
Also, I have a set of collets which are held in the quill with the draw bar. The collets will not hold my endmills or drill bits securely. What I mean is that the end mill will creep up into the collet.
I have one MT#3 x 3/8" mill holder that has a female thread for the draw bar. This one works OK. The endmill is held in place with a set screw. If I could afford it I would buy these holders for each size of tool.
So, after saying all of that, I need help with these two issues.
1-How do I keep tooling with the MT-3 and tang from falling out of the quill?
2-How can I hold various sizes of tooling with my Collete's securely?
Thanks for your help.
SAM