here is a good one

[Krown Kustoms]

this wasnt too bad, just not paying attention

I test fit a sleeve I just got done turning, I made it tight so I had to press it in and out.
In went ok, I was talking on the phone, pressing it out, I got it off center from the base, broke the edge, now its a template.

 

[bearcar1]

Yes but did you swear? th_wtf1 th_confused0052 :redface2: :toilet:


BC1
Jim

 

[Krown Kustoms]

of course, in my native garage talk, mostly four letter words

 

[bearcar1]

Sasa frasking rella rasking .....what did he just say? :big:

BC1
Jim

 

[Krown Kustoms]

now that I think about it, I think that cylinder is cursed. I also broke a parting tool on it. That scared the crap out of me, you never expect things like that to happen. I think the parting tool had a crack in the casting. I looked at the break and saw it wasn't all fresh.