rake60
Well-Known Member
- Joined
- Jul 8, 2007
- Messages
- 4,756
- Reaction score
- 124
Anyone who says they've never had a close call with an end mill is either
lying to you or not paying attention to what they have been doing.
By it's very design an end mill is a hazardous tool. When cutting on the
end or side it can suck down out of it's holder or draw the part up out of
its clamping. Either situation can be potentially dangerous. Get a finger
too close, and the tool doesn't know the difference between metal and
flesh. I saw a big man go down once when he was cleaning up after an
accident at the shop where an operator was wearing a glove and got too
close to an end mill. He picked up a glove and a rather large chunk of
a hand fell out. The tools we use at home are much smaller, but they will
bite the hand that feeds them just as quickly.
Rick
lying to you or not paying attention to what they have been doing.
By it's very design an end mill is a hazardous tool. When cutting on the
end or side it can suck down out of it's holder or draw the part up out of
its clamping. Either situation can be potentially dangerous. Get a finger
too close, and the tool doesn't know the difference between metal and
flesh. I saw a big man go down once when he was cleaning up after an
accident at the shop where an operator was wearing a glove and got too
close to an end mill. He picked up a glove and a rather large chunk of
a hand fell out. The tools we use at home are much smaller, but they will
bite the hand that feeds them just as quickly.
Rick