Search results

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Clarksville Don

    Questing about a flywheel casting issue.

    The pattern could not be seen before the facing cut. From the way drills and the end mill reacted, there were hard spots in the casting. Don
  2. Clarksville Don

    Questing about a flywheel casting issue.

    Thanks for all the input. I did flip the flywheel and do a face cut and the pattern does go through. It does not have the 6 small dots on the second side (first photo). I also faced the first side to final size by taking another .o25 facing cut. The pattern looked like it was starting to go...
  3. Clarksville Don

    Questing about a flywheel casting issue.

    WOB Thanks fo your input. I do have a small carbide tipped boring bar and used it to finish the bore of the first flywheel. Your suggestion of starting with a carbide end mill sounds good. Thanks Don
  4. Clarksville Don

    Questing about a flywheel casting issue.

    I am working on a Red Wing water cooled kit from PM Research. I had an issue getting a drill to run true when drilling the flywheel hub prior to boring and reaming. On the second flywheel I noticed a strange pattern on the face of the hub after I took a facing cut. There is a light colored disk...
  5. Clarksville Don

    Hello from Southwest OHIO

    Sorry to say I can not make it this year.
  6. Clarksville Don

    Hello from Southwest OHIO

    Paul I am about a mile out of Clarksville. I agree figuring out fixtures and machining sequences are part of the fun. Maybe we could meet for lunch some place in Lebanon. Don
  7. Clarksville Don

    Hello from Southwest OHIO

    As suggested here are photos of my engines if I have figured how to post photos.
  8. Clarksville Don

    Hello from Southwest OHIO

    I have been watching and learning from this forum for several years and decided it is time to introduce myself. I started my modeling in the late 90's buy buying a 8 x 20 Grizzly lathe and a RF30 mill/drill. I started with small steam engine kits and worked up to a PM Research #4. I then built a...
Back
Top