Search results

I use doall blade material and silver solder my own, 309-047 1/4" 6 pitch and 308-601 1/4" 32 pitch

I have done 2 band saws with treadmill motors both worked great, also make your own blades out of bulk material and silver solder them together.

there is a royal oak on ebay , also check out hybco that is very similar

yes harden collars are like washers, they are thicker some are ground on both flat surfaces

they don't dig in when you lock them down and through off your setting

Several years ago i made my cushman 8' ajustable like a buck chuck. I used 1/4" 28 set screws and ground off the end flat on a surface grinder. I turned the back plate deeper to work with the 1/4" 28 set screws, and .015 under for adjustment. I also put harden collars on the bolts that hold the...

Has anone built a mill table that you could adjust for height? A friend just bought a combo mill and lathe and the only way you can raise the mill table height is with a riser block, this the older model.

Did you get the pm i sent you on the royal oak some time back? Bigo

For sale a lathe tailstock, was off a harding lathe and remachine to fit a 10" atlas works good $75 pluss shipping or local pick up so. beloit il. ph 815-389-1870

check out royal oak yours is very similar,it is a tap chamfer grinder with different cams for different flutes, not that hard to use

Use a threadmill motor and the control, I have done several they work great and most are free on the curb. Make yor own blades silver solder them your self, make a jig, propain torch, and some sheet silver solder and your in business (Kernbigo)

Not trying to hide anything , I figured if some was interested they would call, now you see my address is in so. beloit il

(sold) I have for sale a lathe 6 station turret, fits a 10" atlas $175 pluss shipping ph 815-389-1870

I have for sale a custom made collet chuck, it take r8 collets, draw bar included, no collets, will fit a lathe with 1 1/2" 8 thread $100 pluss shipping ph 815-389-1870

i know a guy that has a bench top knee mill ph 815-389-9714 ask for Jay (Please lock up sold)

check this out that i built from a linear accutator, cut the lead screw, put on timing pulley and built a speed control which varies the speed and a reversing switch for foward and reverse