Recent content by rodue

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. R

    1/2 scale fruit jar Maytag

    I don't know if this set of castings is of interest to you 5/16 scale no print
  2. R

    scale knuckle head

    I need information on the cam in relation to pistons
  3. R

    1/4 scale International M

    I made the patterns and cast this engine in my shop I made two sand cores I it has a cast iron sleeve. all the brass parts are fabricated
  4. R

    Harley Davidson

    thanks for the help
  5. R

    Harley Davidson

    a couple years back there was print to build a scale model knucklehead engine that could be downloaded. I lost my computer with that info does any one have that web site.
  6. R

    looking for plans for a steam radial engine

    I want to thank every one for the information now all I have to do is get to run
  7. R

    1/4 scale international model M

    I made several engine before this from casting I made, the best way to make patterns is to have something to look at and scale down for the size When it comes to casting it you will have many failures. You should design your pattern for machining so it be held firmly in the mill to start
  8. R

    1/4 scale international model M

    go to you tube and down load MVI1354 1/4 scale international M, to see it running
  9. R

    1/4 scale international model M

    I made one engine using my castings, I always make two sets of castings be cause of its size many parts were fabricated. Its a good running little engine
  10. R

    6 cylinder steam engine

    Hi this engine is my own design the air is feed on the back side to each cylinder this is working ok, the problem is the crankshaft doesn't stay the same as it turns to keep in time. you can see by the picture the rotor is the problem.
  11. R

    6 cylinder steam engine

    I was needing the solution for my engine on the crankshaft does not turn like it should causing it to lose timing any one know the solution.
  12. R

    looking for plans for a steam radial engine

    any one know where I could down load prints for steam engine
  13. R

    Breisch Associated Casting Kit

    the mag works it using peso from a charcoal lighter you have to change the cam and a way to stop it doing the coasting other wise the peso doesn't last, I made it look like a Wico.
  14. R

    Holt 75 from Italy

    sorry I am late with a reply, without a oil ring it spits oil on the engine so I added the tube, for easer clean up
Back
Top