Help Support Home Model Engine Machinist Forum:
M
metalmangler
- Messages
- 41
- Reaction score
- 23
Latest activity Postings About
-
-
Mmetalmangler reacted to BWMSBLDR1's post in the thread Needle bearings in a model diesel ? with
Like.
First recall that antifriction bearings are used on both ends of the rod because the combustion loads and the inertial loads combine to... -
MI can't speak for anyone else, but I am finding this very interesting. One important point emerges (actually, more than one, but this...
-
MMaybe you have the gears too close. You needs a tiny space, about the thickness of paper when you set the gears. I always use a strip...
-
Mmetalmangler replied to the thread Wind Powered Wood Water Pump.Sound and video OK for me too - using Firefox on Linux Mint. That pump is an impressive piece of engineering.
-
MHi Metalmangler (good name!) You are correct. I think with all electrics there is detail which is overlooked. The capacity of a ring...
-
Mmetalmangler replied to the thread HELP, my shop is a MESS.One thing to remember about UK double sockets is that, although the individual sockets are rated at 13 amps, the double socket unit as a...
-
Mmetalmangler replied to the thread What have you been doing today?.You only think you're successfully resisting squirrels because the devious little B******s want you to think that...
-
MCheers Prop! Remember the number one rule. - "Keep the Hooker happy". (Sorry, non-rugby people may mis-interpret that one). K2
-
MAny more political discussion in this thread will be either edited or oeleted.
-
Mmetalmangler reacted to william_b_noble's post in the thread What have you been doing today? with Like.
Let's keep divisive us politics out of this forum. Take it elswhere
-
MI don’t have to put things away to lose them. I can do it while standing at the lathe and not moving an inch. Where is that mic? It...
-
MI just hope that my relatives don't sell everything for what i told them it cost;)
-
MIf dissatisfied with a part, I think of salvage and rework first. Can I mod and come out OK for its use and purpose? Or how bout...
-
MWork out where the set screw needs to be along the shaft then machine an undercut approx .020 in. deep, sufficient width to fit the...
-
MWhen I can't find a particular tool, I look around at a horrendous mess I've made over a few weeks. Then I spend a few hours putting...
-
-
Loading…
-
Loading…