Recent content by kennyd

Was on my Clausing 4900 series lathe, I replaced it with a Aloris QCTP. There is no name on it but it appears to be nice quality. Best offer, shipping will be $11.40 in a flat-rate USPS Priority box. Update 3/3/12: Sold.

I can not prove they work, buy they came off of my Bridgeport before it was converted to a VFD by the previous owner so I assume everything to be in working order. Best offer, shipping will be $11.40 in a flat-rate USPS Priority box. Update 3/3/12: Sold.

These came with my Clausing lathe but it has a QC gearbox so your knows what they where/are for, but something old and American no doubt. I tried to highlight the numbers with red paint but it did not turn out well, they are 36,40,44,46,48 Best offer, shipping will be $11.40 in a flat-rate...

This is begging for attention, just needs some TLC. They don't make 'em like this anymore! Best offer, shipping will be $11.40 in a flat-rate USPS Priority box.

Bill, I tried logging at about 1am through 5am this morning (on night work this week) and got this message: Perhaps a victim of a major hack?

Not cheap, but Aloris does make one: http://www.drillspot.com/products/524851/aloris_tool_technology_axa-35_dovetail_drill_chuck_holder_toolholder

I just got home...It was kind of disappointing this year-it seemed really slow and very few vendors where there compared to years past. I guess the bad economy has taking it's toll :-\

I use a Teco FM50 drive on my Clausing lathe...

I will be there also...Saturday is the best day to go!

It has been working fine for me.

Of the three choices listed here is the way I would list them from OK to worst for machine tools like Mills, Lathes, ect.: 1. Grizzly 2. Enco 3. HF Now for hand tools/machine tooling I would swap #1 and 2, but HF is ALWAYS on the bottom of the list for me ;D This is just my opinion-It may be...

For $20 you can get this automatic switch to turn on the vacuum for you: http://www.sears.com/shc/s/p_10153_12605_00924031000P

I know it's 1/2x20, but is it RH or LH thread? http://www.grizzly.com/products/Quill-Stop/G9306

Thanks so much for taking the time to post that :bow:

Thanks Kermit, any chance you have the part # or MCS #?