HMEL's latest activity

Home Model Engine Machinist Forum

Help Support Home Model Engine Machinist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  • H
    HMEL replied to the thread Unusual twin cylinder engine design.
    Yes, it is possible but the vibration impulses would be very difficult to manage. Not sure how you compensate for that . The vibration...
  • H
    HMEL replied to the thread Which Spindle coolant to use?.
    Depends on how you cool the water. I would be tempted to modify a air conditioner for that service and use a glycol with a rust...
  • H
    HMEL replied to the thread Direct drive vs. geared flywheel?.
    Flywheels are used to store inertial energy to help balance engine vibration and force the crank past a dead center point. It smooths...
  • H
    I would be tempted to reverse the angle iron to open up the air flow area and get rid of the dead spots where ash can accumulate. And...
  • H
    There is a part of this story that is missing. It deals with the economics of standards and who sets them. The standards are often...
  • H
    HMEL replied to the thread Experimental Flash Steam and others.
    And this can be proved mathematically using thermodynamics that the efficiency is directly proportional to the compression ratio. The...
  • H
    HMEL replied to the thread US State Boiler Code.
    k2: Without doing research to see if these specs have been updated I will share with you what I have. To be considered a miniature...
  • H
    HMEL replied to the thread US State Boiler Code.
    The states have jurisdictional authority of all codes. And it is in this respect one must be careful because what some do is reference...
  • H
    HMEL reacted to willray's post in the thread First and Third Projection Symbols with Like Like.
    HP 41CX sir. HP calculators have no equal.
  • H
    This may not have acceptable materials for what you want to do. You could use ASME pipe and weld high quality steel and use one of...
  • H
    HMEL replied to the thread Monotube Flash Boiler Design.
    Depends on which side of the curve you ride. You are operating so close to the critical point it is doubtful you can keep the state...
  • H
    HMEL replied to the thread Monotube Flash Boiler Design.
    The ph diagram in english units shows critical temperature at 532 abs lbs/ f in2 and temperature of 382 F. Given the high heat flux...
  • H
    HMEL replied to the thread Monotube Flash Boiler Design.
    All that taken into consideration, fluids transferring heat just consider the maximum temperature R123 can stand. Nucleate boiling will...
Back
Top