HMEL's latest activity

Depends on how you cool the water. I would be tempted to modify a air conditioner for that service and use a glycol with a rust...

Flywheels are used to store inertial energy to help balance engine vibration and force the crank past a dead center point. It smooths...

I would be tempted to reverse the angle iron to open up the air flow area and get rid of the dead spots where ash can accumulate. And...

There is a part of this story that is missing. It deals with the economics of standards and who sets them. The standards are often...

And this can be proved mathematically using thermodynamics that the efficiency is directly proportional to the compression ratio. The...

k2: Without doing research to see if these specs have been updated I will share with you what I have. To be considered a miniature...

The states have jurisdictional authority of all codes. And it is in this respect one must be careful because what some do is reference...

HP 41CX sir. HP calculators have no equal.

This may not have acceptable materials for what you want to do. You could use ASME pipe and weld high quality steel and use one of...

Depends on which side of the curve you ride. You are operating so close to the critical point it is doubtful you can keep the state...

The ph diagram in english units shows critical temperature at 532 abs lbs/ f in2 and temperature of 382 F. Given the high heat flux...

All that taken into consideration, fluids transferring heat just consider the maximum temperature R123 can stand. Nucleate boiling will...

Except water will remain a liquid and the R123 will be a gas. But a more common example is the heat transfer difference between water...

You will be dealing with gas flow. The probability is high because of the sharp turns in the assembly choke flow will occur and flow...

K2 is absolutely correct. R123 heat of vaporization is about 70 btu/lb while that of water is 800 btu/lb give depending of course on...