Hello everyone,
Has anyone ever ordered any tools from Alibaba in China?
I've seen some nice end mills etc on their site and wondering if anyone has had any experiences ordering from them.
Cheers
Wayne
Hello Petertha,
Got my Phase II rotary table today.
Made in China. Just so you know it looks pretty good despite the origin.
I have a job on the mill this week but I`ll get it cleaned up and give it a run.
Busy Bee Tools have small 4 jaw chucks for rotary tables in their sale flyer.
Cheers
Wayne
Hello Petertha,
I was going to order from Travers until I saw the 15% off deal that Emco was offering until the 7th of January.
I have ordered from KBC and find their service is quite good in Canada.
I ordered a 6 inch from Busy Bee a few years back but it was complete junk. The pinion gear had...
Hi Petertha,
I just ordered a Phase II from Enco
link below
http://www.use-enco.com/CGI/INSRIT?PARTPG=INSRAR2&PMAKA=327-3973&PMPXNO=22532528
I think this will be better quality than the KBC
I have yet to order the dividing plates.
Cheers
Wayne
That would be great Colin.
Put ii in the downloads section , that way everyone could share in your experience
Thanks for the Busy Bee link Luc,
I'll put this in my next order with Busy Bee
Cheers
Wayne
I finally had the time to do a short video of the wobble plate running.
I used the steel flywheel as it didn't idle well using an aluminum one.
I'm pretty happy at the way it turned out.
http://www.youtube.com/watch?v=bgSlu04GEuk&feature=youtu.be
Hope you enjoy it.
Cheers
Wayne