Help Support Home Model Engine Machinist Forum:
D and D
- Messages
- 35
- Reaction score
- 53
Latest activity Postings About
-
-
Here is a run before I polished the base plate. -
I recently completes a poppin engine. It was a fun project to get me back into machining. Poppin Vacuum Engine by Sparticusrye posted...
-
Started on this over a year ago, but got put to the side while my attention was put toward the construction of my shop, a picture is in...
-
This is my second Economy hit and miss engine, has a one piece crank, S/S Machine and Engineering electronic buzz coil ignition and runs...
-
I tend to use 303 Stainless for valves and don't have a problem drilling the end with a BS0 ctr drill and turning with a DCGT insert, I...
-
D and D replied to the thread Harden the camshaft and crankshaft..Yes I agree, I case harden cams, but for the crank I think it is worth a look.
-
D and D: I understand that for (example) cam lobes, Chrome plating can suffer fatigue problems (short lifetime) as the hard plating on a...
-
D and D reacted to cheepo45's post in the thread Parcell and Weed Vertical air cooled engine with
Like.
Here is the engine cleaned up and ready for the shows! This was the most challenging of my engine builds to date. it has a lot of very... -
D and D replied to the thread Harden the camshaft and crankshaft..Chrome plating is not a bad solution IMO.
-
Congratulations, Nice engine and runs great ! 👍👍👍
-
great ! congratulations, a nice and running well engine ! the engine responds pretty well to the carb setting, vrooom vroom
-
D and D replied to the thread Westbury Wallaby Likeness.Finished Engine is a 36cc parallel (360 Degree) twin based loosely on the Wallaby design by Edger Westbury. Capacity: 2.2 Cubic Inch...
-
Today I made the valve lifter or I made two of them. I forgot to leave material for the roller bearing on the first try and then I...
-
-
Loading…
-
Loading…