An easy way is to press the 'Prt Sc' button at the time you want, even as a video plays.
Then open 'Paint', paste it in there and crop as needed then save in the chosen format.
Easy.
I got the drawings off John Tom's site to do this.
https://grabcad.com/library/elmer-17-pumping-engine
It is 11 pages at 900kb with all pieces dimensioned in there.
If this is what you are after then shoot me a PM with your email and I will send it to you.
Cheers.
Just a few questions on the drawing and some pictures of what I think it looks like as well as a 3D PDF that people can open and look around the part if they want.
Not much of a casting project just trying to save a bit of room and do a bit of cleaning.
I have been collecting anything and everything ally to be used at some later date to start casting some engines and other things.
So over the past couple of days I have melted most of my stock pile down...
Hey Paul and Dave.
There is already a brace for the legs and it is 100 x 8.
I also believe that with the clamps as they are, they would offer more than enough torsional strength and as there is a trolley that if you did try and lift something at an angle ( which you shouldn't do anyway )...
Just something I designed and yet to build.
Has the capability to adjust height from 2 meters to just over 3 meters.
The top beam is clamped in so you can either adjust width or put a bigger beam in if needed.
Will build this one day.
Yes and no.
An End Mill normally is designed to come in from the end or edge of the job and a Slot Mill ( Slot Drill ) is designed to cut down into the job and then move X or Y.
However these days they simply make just about all mills capable of plunging into the job.
The first picture provided...
A picture is worth a thousand words, I hope.
Not all that hard and you only need clearance for the OD as you can see.
Just a bit of quarter inch tool steel.
Then whilst it is still setup, if the lathe can run backwards, you can also prep turn the flange using the same tool at the back.
If the...