Search results

looking good. Ron

Does any one know where Draw-Tech went or what's happened to him? I tried sending him am IM and no response. Hope he is OK. Ron

Today at 4:40 AM Add bookmark #27 I am building the Knucklehead by Draw-Tech and I can't seem to find the demission's for locating and boring the cam box for the distributor. Can someone help me put? Thanks Ron

I am building the Knucklehead by Draw-Tech and I can't seem to find the demission's for locating and boring the cam box for the distributor. Can someone help me put? Thanks Ron

Brilliant!!👍👍👍 Ron

Yes, please bore us. Ron

I just made aluminum pistons for my Mastiff and they work fine. Ron

I have a Grizzly 10-22 and like it very much. It has done everything I’ve asked of it, I built my Hodgson 9 cyl Radial on it and my G 0704 Grizzly bench top mill drill. I’ve had them for about 15 years. Ron. aka ozzie46

Tell that to Steve Hucks of Lil Demon fame. I’m running his 8 40 plugs in my Lil Demon with no issues. He manufactures and sells them. I think he even has a 6 32 size too. take a look at this site run by Steve Hucks of Lil Demon fame. I’m running his 8 40s in my lil demon with no issues...

Thanks Ron

Amazing project and your persistence over the years is a testament to dedication to a subject. Congratulations. Well done sir. Ron

Thank you. The plans state on them that the engine is not intended to mounted on a model airplane. That being said it probably could be, but I would never put something in the air that I spent almost 2 years building. I flew RC so I know what happens to things that go up, they must come down...

Great Job ,sounds good. Ron

Those are great. Ron

Thanks Steve , it keeps running better each time I run it. You should see my "wall of shame" of "practice parts". It's quite extensive Ron

Started Feb2022, 1st startup 9/16/23. 1st good runs 9/18/23. All manual machining although I do have DROs on my bench mill. Wish to thank Steve Hucks for an assist on crank and Terry Mayhugh for some info. Ron Osborn,aka ozzie46

I have a cheap import and when I tighten work in the jaws the rear jaw moves .007 +. Have solid rear jaw tilting vise I use now. The cheap import rear jaw is bolted down over a 3/8 or 1/2 in . ( can't remember now ) square key. Ron

Mine too

George, I remember following your Flat head V-8 build and the trouble you had getting it to run. Did thread just vanish into thin air? Ron

Well done sir!!!🤩 Ron