Recent content by WMarco

If the angle isn't the problem but the accuracy of your holes you could use your 12 mm shaft, Drill the hole, ream/turn it to the right dimension for your 12mm shaft position. Now you can use your 12mm shaft for locating the hole's The precision you get depends on you re shaft/hole the only...

Perhaps it's a possibility to do it like this: You can calculate or draw the distance needed for your angle. Good luck

Hey pete, I think you're searching for a 3degree die cutter, http://en.hoffmann-gmbh.de/K39/products/192071_1.htm So far I know, they ship worldwide. So you first make your cut with this mill, and then with a ballmill for you're radius. Wmarco

Thanks, I made the flywheel from barstock, First I made both bronze parts, and then the aluminium flywheel. The bronze cylinders aren't a press fit but the allu flywheel is heated so it "grew" and by cooling it down wit the cylinder in it, it will never get out :)

I'm a newbie here, I made the elbow from john-tom, It's my first engine but I liked it very much to build. The squareness was a Little problem, but it runs :) Here are the picture's All comments are welkom :)