Help Support Home Model Engine Machinist Forum:
V
Vietti
- Messages
- 222
- Reaction score
- 100
Latest activity Postings About
-
-
VVietti replied to the thread Entry level machine.I'd get a lathe if I could have only one machine tool. The lathe is said to be the only tool that can replicate itself, thus the...
-
VVietti reacted to Jasonb's post in the thread Time for a new Horizontal Hit and Miss engine with
Like.
Brian although not a Canadian site I use this one which allows you to enter diameter and various reaches though not 16mm. You could use... -
VVietti replied to the thread Time for a new Horizontal Hit and Miss engine.Jason, Thanks for the link to Greenspark. They have a great selection of ignition parts. Bought a coil! John
-
VGot onto the crankcase which involved a lot of metal removing (thank God for ripper cutters) and at the same time to remember what bits...
-
VVietti replied to the thread Time for a new Horizontal Hit and Miss engine.Nice engine! How do you remove the bearings once the crank is in for disassembly?
-
VVietti reacted to Foketry's post in the thread 18 Cylinders Isotta Fraschini (straight six-cylinder x3 ) with Like.
Boring of bushing seats for crankshaft I have built a boring bar that is more than twice the length of the engine block to carry out...
-
VVietti replied to the thread Time for a new Horizontal Hit and Miss engine.How about a vertical?
-
VVietti replied to the thread Valve Gear Design for Steam Engines - My approach.Good to know, I thought the upper video was a water pump.
-
VVietti replied to the thread V-TWIN---MAYBE V-4.Switch carbs??
-
VVietti replied to the thread Single cylinder horizontal enigne as test bed for multi cilinder engine design.Got it, seems reasonable. Thanks, John
-
VVietti replied to the thread Single cylinder horizontal enigne as test bed for multi cilinder engine design.Probably a dumb question but is there any way to make this sort of clamp that keeps the flywheel spokes in alignment, one to the other...
-
VVietti replied to the thread Carburetor with glass jar fuel-tank as a single unit.When you use this kind of gas tank, a very small tube for the fuel will hold the gas up on the needle by capillary attraction like a...
-
VVietti replied to the thread Cam duration for slow running four cycle model engine.Don't know the technical answer but my Silver bullet runs pretty well and slow with no overlap and the intake opens at TDC, If it opens...
-
VVietti replied to the thread Looking for input on a cylinder block corrosion issue..I too have used the computer type radiators with success. I buy the more expensive brass ones instead of the aluminum ones so it's easy...
-
VVietti replied to the thread V-TWIN---MAYBE V-4.AIRC you used an O ring with 3 ci rings. Maybe try the piston with only the o rings or with only the CI rings??
-
-
Loading…
-
Loading…