You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
Help Support Home Model Engine Machinist Forum:
This site may earn a commission from merchant affiliate
links, including eBay, Amazon, and others.
-
-
S
Terry and Don, you are both correct. Heat is the enemy in the DC-DC converter but not a problem in the HV section. As you increase the...
-
S
Terry, you are correct on the slightly smaller value capacitor so it can charge faster. The Magnum was not designed to run strictly on 6...
-
S
Fly Wheel Bearing A-Frame Support
This should work. Still need to make the cap and bore it for the bearings (after I get them).
Milling...
-
S
The piston was turned from some 25mm cast iron bar using the cylinder to gauge it's diameter. Then into an ER32 Block to first have the...
-
S
Inlet and outlet assemblies for the rear bowl were machined from brass. Each is made up of a hose barb and threaded body that was...
-
Loading…
-
Loading…